Chevrolet 2007 Corvette Spécifications télécharger pdf (Page 122)

4. The indicator light will blink slowly. In order

from left to right, and within two and one-half

minutes, enter each switch setting into the

Universal Home Remote System. Push

one button for each switch as follows:

• Left button = “on” switch position.

• Right button = “off” switch position.

• Middle button = “middle” switch position.

5. After entering the switch settings, press and

release all three buttons at the same time.

The indicator lights will turn on.

6. Press and hold the button you would like to

use to control the garage door until the

garage door moves. The indicator light above

the selected button should slowly blink.

You may need to hold the button from ﬁve to

55 seconds.

7. Immediately release the button when the

garage door moves. The indicator light will

blink rapidly until programming is complete.

8. Press and release the button again. The

garage door should move, conﬁrming that

programming is successful and complete.

To program another device such as an additional

garage door opener, a security device, or

home lighting, repeat Steps 1–8, choosing a

different function button in Step 7 than what you

used for the garage door opener.

Programming Universal Home

Remote — Rolling Code

Rolling code garage door openers are used for

garage doors produced after 1996 and are

code protected. Rolling code means the coded

signal is changed every time your remote control

garage door opener is used.

Programming a rolling code garage door opener

involves time-sensitive actions, so read the

entire procedure before you begin. If you do not

follow these actions, the device will time out

and you will have to repeat the procedure.

122

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 485 486

Commentaires sur ces manuels

Pas de commentaire