Chevrolet 2007 Corvette Spécifications télécharger pdf (Page 137)

Installing the Roof Panel

{CAUTION:

An improperly attached roof panel may

fall into or ﬂy off the vehicle. You or

others could be injured. After installing

the roof panel, always check that it is

ﬁrmly attached by pushing up on the

underside of the panel. Check now and

then to be sure the roof panel is ﬁrmly in

place.

Notice: If you drop or rest a roof panel on its

edges, the roof panel, paint and/or

weatherstripping may be damaged. Always

place the roof panel in the stowage receivers

after removing it from the vehicle.

In most cases, it makes it easier if two people

re-install the roof panel.

1. Park on a level surface and set the parking

brake. Shift an automatic transmission into

PARK (P). Shift a manual transmission

into NEUTRAL.

2. Check that the front release latches and the

rear release latch on the vehicle’s roof

opening are in their opened positions before

attempting to install the roof panel.

3. If the roof panel is stored in the rear storage

area of the vehicle, grasp the rear edge of the

roof panel with both hands and gently lift it

up and remove it from the storage area.

4. Carefully place the roof panel over the top of

the vehicle.

5. Position the rear edge of the roof panel to the

weatherstrip on the back of the roof opening.

Then align and ﬁt the pins at the rear of

the roof panel inside the openings in the rear

overhead weatherstrip. Gently lower the

front edge of the roof panel to the front of the

roof opening.

137

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 485 486

Commentaires sur ces manuels

Pas de commentaire