Chevrolet 2007 Corvette Spécifications télécharger pdf (Page 92)

Cell phone chargers can interfere with the

operation of the Keyless Access System. Battery

chargers should not be plugged in when starting

or turning off the engine.

To start your vehicle, do the following:

1. For an automatic transmission, with your foot

on the brake pedal, press the START button

located on the instrument panel. For a

manual transmission, while pressing in the

clutch, press the START button.

If there is not a keyless access transmitter in

the vehicle or if there is something causing

interference with it, the DIC will display

NO FOBS DETECTED. See DIC Warnings

and Messages on page 212 for more

information.

2. When the engine begins cranking, let go of

the button and the engine cranks automatically

until it starts. If the battery in the keyless

access transmitter is weak, the DIC displays

FOB BATTERY LOW. You can still drive

the vehicle.

See “Battery Replacement” under Keyless

Access System Operation on page 74 for more

information. If the fob battery is dead, you

need to insert the fob into the fob slot to enable

engine starting. See “No Fobs Detected”

under DIC Warnings and Messages on

page 212.

3. Do not race the engine immediately after

starting it. Operate the engine and

transmission gently until the oil warms up and

lubricates all moving parts.

4. If the engine does not start and no DIC

message is displayed, wait 15 seconds

before trying again to let the cranking motor

cool down.

If the engine does not start after 5-10 seconds,

especially in very cold weather (below 0°F

or −18°C), it could be ﬂooded with too much

gasoline. Try pushing the accelerator pedal all

the way to the ﬂoor while cranking for up to

15 seconds maximum. Wait at least 15 seconds

between each try, to allow the cranking motor to

cool down. When the engine starts, let go of the

accelerator. If the vehicle starts brieﬂy but then

stops again, do the same thing. This clears the

extra gasoline from the engine.

92

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 485 486

Commentaires sur ces manuels

Pas de commentaire