Chevrolet 1967CHEVY II Manuel d'installation télécharger pdf (Page 8)

4.0 TOOLS NEEDED

In addition to your regular tools, you will need, at least, the following tools:

Crimper tool

Note: Use a quality tool to avoid over crimping

Wire stripper

Test light or volt meter

Small ( 10 amp or less) battery charger

5.0 REMOVAL OF ORIGINAL WIRE HARNESS

5.0.1 Locate the engine and front harness and unplug them from the bulk head connector at

the firewall. Disconnect the the other end of each of the wires and remove the harness

from the vehicle.

5.0.2 Locate the two screws that secure the fuse block to the firewall and remove. Disconnect

the wires from the dash cluster, switches and lights. Remove the door sill plate and kick

panel on the driver’s side floor for access to the wires going to the rear. Remove the rear

light sockets and retain for reuse. Remove the rear harness from the vehicle.

Figure 5.1 Engine and Front Harness

Figure 5.2 Original Fuseblock

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Pas de commentaire

Chevrolet 1967CHEVY II Manuel d'installation Page 8