Chevrolet 1967CHEVY II Manuel d'installation télécharger pdf (Page 17)

8.3.3 Locate the maxi fuse holder and mount it to the passenger side inner fender

panel as shown in figure 8.13. Take the starter Red wire (916) and route it to the

maxi fuse holder. Cut the wire, crimp on a ring terminal and connect it to a fuse

holder terminal. Take the remaining wire that was cut off and crimp on a ring

terminal, connect it to the other side of the fuse holder. Take the other end and

route it to the starter solenoid and connect it to the large battery terminal.

NOTE: If using an alternator larger than 65 Amps, you will need to review the

instructions in the PP-662 ALTERNATOR WIRE KIT (supplied in bag in with this

harness) before you make any maxi fuse or starter connections.

CAUTION: TO PROTECT THE ENTIRE SYSTEM THE MAXI FUSE MUST BE

INSTALLED AS INSTRUCTED.

8.3.4 Route and connect the starter, coil, oil sender, choke, temp sender, a/c

compressor and alternator wires.

Figure 8.14 Electric Choke Connections

Figure 8.13 Maxi Fuse

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Pas de commentaire

Chevrolet 1967CHEVY II Manuel d'installation Page 17