Chevrolet 1967CHEVY II Manuel d'installation télécharger pdf (Page 18)

Figure 8.15 Alternator Connections

Note: In with the kit you should find a connector with a Blue and a White wire labeled

“Alternator pigtail”, this connector will be used as shown when using an external

regulator system. If you have converted to a internal regulated system you will not

need the alternator pigtail but will use the connector and terminals provided.

CAUTION : If using an alternator larger than 65 amps, you will need to use the PP-662

ALTERNATOR WIRE KIT supplied in a bag in the box. with this harness.

Note: This will be used along with the alternator wires in the main harness.

8.3.5 If you have a `67 model vehicle you will connect the brake pressure warning

switch as shown below. The `66 model vehicle did not have a brake warning

switch, you will tape and stow the wire.

Figure 8.16 Brake Pressure Warning Switch Connection

Internal Regulator

External Regulator

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Pas de commentaire

Chevrolet 1967CHEVY II Manuel d'installation Page 18