Chevrolet 1967CHEVY II Manuel d'installation télécharger pdf (Page 21)

Figure 8.21 Turn Switch Connector Removal

Figure 8.22 Turn Switch Connector Pin-out

8.5.4 You will need to remove and use the turn signal switch connector from the

original harness on the new harness. With the face of the connector toward you

locate the locking ear cutout on each side of the terminals (FIGURE 8.21). Using

a small screwdriver or end of a paperclip push the locking ears in towards the

sides of the terminal until the terminal is released and will pull out of the

connector.

8.5.5 Using one of the two illustrations below, insert the terminals from the new

harness into the old turn switch connector. NOTE: When it is stated that the

connector is viewed from the face view it is meaning that it will be showing it

from the opposite side than the wires come out.

NOTE: The `66 connector is a 8-way connector and the `67 is a 9-way connector. The

Brown wire will not be used with the `66 model turn switch, tape and stow it.

Locking Ear

Locations

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Pas de commentaire

Chevrolet 1967CHEVY II Manuel d'installation Page 21