Chevrolet 1995 S10 Pickup Manuel du propriétaire Page 236

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 380
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 235
Tightening Wheel Nut
Tightening Sequence
Use the wrench to tighten the wheel nuts firmly in
a
criss-cross sequence as
shown. Remove the wheel blocks.
Storing the
Jack
and
Spare
Tire
Return the jack, wheel wrench and wheel blocks to the proper location in
your vehicle’s rear area. Secure
the
items and replace the jack cover. Put the
flat tire where the spare tire was stored. If you have the underbody carrier:
1.
Put
the tire on the ground at the rear
of
the vehicle, with the valve stem
pointed down and to the rear.
2.
Pull the retaining bar through the wheel.
3.
Put the chisel end of the wheel wrench, on an angle, through the hole in
the rear bumper and into the hoist shaft. Turn the wheel wrench
clockwise until the tire is raised against the underside
of
the vehicle.
You will hear two “clicks” when the tire is secure, but pull
on
the tire to
make sure.
5-34
Vue de la page 235
1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 379 380

Commentaires sur ces manuels

Pas de commentaire