Chevrolet Roadtrek Manuel d'utilisateur Page 53

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 78
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 52
WATER SYSTEMS
DDoocc NNoo::
21906532-210C05
RReevv::
02
CCooppyyrriigghhtt ©© HHaannmmaarr MMoottoorr CCoorrppoorraattiioonn 22000055 GG--55
The fresh water tanks can also be filled through the city
water inlet located behind the rear lockable driver side
access drawer,for location,see the Daily Living section.The
use of the city fill is not possible when in the winter
operation mode.
To fill the tank:
1. Prior to using city fill,ensure water system is in
summer use mode,(see Picture G-P2 on page G-1).
Connect a hose to the city water inlet connection,
(see Picture G-P10).
2. To fill the exterior fresh water tank,open the city
water tank fill shut off valve,(see Picture G-P11).
3. Open the water source moderately.
4. When the tank is full,water will overflow in the
same manner as when using the gravity fill,(see
previous page).
5. To fill the interior fresh water tank,ensure the
water system is in winter mode,(see Picture G-P1
on page G-1).Repeat steps 2-4.
6. Close the city water tank fill shut off valve,(see
Picture G-P5).
CITY WATER CONNECTION:
NOTE: City water connection can only be used in summer
operation mode.
The city water inlet connection is located in the small
compartment behind the large lockable driver side storage
compartment,(see Picture G-P10).To connect the water
system to an outside source:
1. Ensure that the water pump is turned off.
2. Close the city water tank fill valve by turning the
handle to the vertical position,(see Picture G-P12).
3. Be sure that all interior faucet's are closed to
prevent spillage.
4. Open the city water source slowly to prevent
excessive water force inside your vehicle.To
protect your system from excessive pressure from
water supply systems encountered in some areas,a
water pressure regulator should be used.Such a
regulator is not supplied with your vehicle.
5. Note that this connection by-passes the water
pump and fresh water tank.Therefore,the use of
these items is not necessary when connected
directly to an external water source.
Picture G-P12:Closed position of the city water tank
fill valve.
Picture G-P11:Open position of the city water tank
fill valve.
Picture G-P10:Location of the city water inlet
connection.
Vue de la page 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 77 78

Commentaires sur ces manuels

Pas de commentaire