Chevrolet Roadtrek Manuel d'utilisateur télécharger pdf (Page 20)

FRONT LOUNGE SEATS:

To convert the lounge seat into a single bed:

1. Swivel the passenger

captain’s seat 90

degrees clockwise

so that the backrest

is toward the

center aisle.Be sure

all armrests are in

an upright position,

(see Picture B-P15).

2. Slide out the drawer

under the

passenger lounge

seat and fully

extend the drawer

forward until it

touches the raised

platform,(see

Picture B-P15).Raise

the support block

located at the front

of the drawer,

(see Picture B-P16).

3. Lift the lounge seat

back rest cushion

upward.Remove

from its metal

support and place it

flat on top of the

drawer,with the

tapered end

forward,

(see Picture B-P17).

To convert back to a

lounge seat,perform

these steps in reverse

order.

The lounge and optional 2 rear passenger seats are designed to carry passengers while your vehicle is in motion

and are equipped with seat belts installed for their protection.All passengers must be seated in the front captain’s

seats,lounge seats and optional 2 rear passenger seats,facing forward with seat belts fastened while vehicle is in

motion.All other seats are not to be occupied while vehicle is in motion.The lap belts must be worn across the hips

and not across the abdomen.Passengers must sit well back in the seat and in an upright position.

DAILY LIVING

DDoocc NNoo::

21906532-210C05

RReevv::

Picture B-P16:Raised support.

Picture B-P15:Extended drawer.

Picture B-P14:Swiveled front captain seat.

Picture B-P17:Front lounge bed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 77 78

Commentaires sur ces manuels

Pas de commentaire

Chevrolet Roadtrek Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Chevrolet Roadtrek