Chevrolet 2012 Corvette Manuel d'utilisateur télécharger pdf (Page 294)

Black plate (18,1)

Chevrolet Corvette Owner Manual - 2012

10-18 Vehicle Care

2. Once the oil has been drained

from the engine, remove the

engine oil filter and allow the oil

to drain.

3. Re‐install both drain plugs and

tighten them to 25 Y (18 lb ft).

4. Replace the oil filter and

tighten it to 30 Y (22 lb ft).

See Maintenance Replacement

Parts on page 11‑14 for the

correct filter.

5. Oil is filled through the opening

in the top of the external engine

oil tank. Remove the oil fill cap.

6. Add 9.9 L (10.5 quarts) of oil to

the oil tank. See Capacities and

Specifications on page 12‑2.

7. Install the oil fill cap and insert

the dipstick, if removed.

8. Start the engine and let it run at

idle for at least 15 seconds.

This will circulate the fresh

engine oil through the lubrication

system.

9. Shut off the engine and check

the oil level as described under

“Checking Engine Oil (Z06, ZR1,

and Grand Sport).”

Selecting the Right Engine Oil

Selecting the right engine oil

depends on both the proper oil

specification and viscosity grade.

See Recommended Fluids and

Lubricants on page 11‑12.

Specification

Use and ask for licensed engine

oils with the dexos1™ approved

certification mark. Engine oils

meeting the requirements for the

vehicle should have the dexos1

approved certification mark.

This certification mark indicates

that the oil has been approved

to the dexos1 specification.

Corvette recommends Mobil 1

®

engine oils that meet the

requirements of the dexos1

specification for its dry‐sump

equipped engines.

Notice: Failure to use the

recommended engine oil or

equivalent can result in engine

damage not covered by the

vehicle warranty. Check with your

dealer or service provider on

whether the oil is approved to the

dexos1 specification.

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 431 432

Commentaires sur ces manuels

Pas de commentaire