Chevrolet 2004 Monte Carlo Spécifications télécharger pdf (Page 103)

100

101

Erasing HomeLink

Buttons

To erase programming from the three buttons do the

following:

1. Press and hold down the two outside buttons until

the indicator light begins to ﬂash, after 20 seconds.

2. Release both buttons. Do not hold for longer than

30 seconds.

HomeLink

is now in the train (learning) mode and can

be programmed at any time beginning with Step 2

under “Programming HomeLink

.”

Individual buttons can not be erased, but they can be

reprogrammed. See “Reprogramming a Single

HomeLink

Button” next.

Reprogramming a Single HomeLink

Button

To program a device to HomeLink

using a HomeLink

button previously trained, follow these steps:

1. Press and hold the desired HomeLink

button.

Do not release the button.

2. The indicator light will begin to ﬂash after

20 seconds. While still holding the HomeLink

button, proceed with Step 2 under “Programming

HomeLink

.”

Resetting Defaults

To reset HomeLink

to default settings do the following:

1. Hold down the two outside buttons for about

20 seconds until the indicator light begins to ﬂash.

2. Continue to hold both buttons until the HomeLink

indicator light turns off.

3. Release both buttons.

For questions or comments, contact HomeLink

1-800-355-3515, or on the internet at

www.homelink.com.

2-39

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 415 416

Commentaires sur ces manuels

Pas de commentaire

Chevrolet 2004 Monte Carlo Spécifications Page 103

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Chevrolet 2004 Monte Carlo