Chevrolet Tahoe, Suburban 2007 Spécifications télécharger pdf (Page 178)

7. Press and hold the button you would like to

use to control the garage door until the

garage door moves. The indicator light above

the selected button should slowly blink.

You may need to hold the button from ﬁve to

55 seconds.

8. Immediately release the button when the

garage door moves. The indicator light will

blink rapidly until programming is complete.

9. Press and release the button again. The

garage door should move, conﬁrming that

programming is successful and complete.

To program another device such as an additional

garage door opener, a security device, or

home lighting, repeat Steps 1 through 8, choosing

a different function button in Step 7 than what

you used for the garage door opener.

Programming Universal Home

Remote — Rolling Code

Rolling code garage door openers are used for

garage doors produced after 1996 and are

code protected. Rolling code means the coded

signal is changed every time your remote control

garage door opener is used.

Programming a rolling code garage door opener

involves time-sensitive actions, so read the

entire procedure before you begin. If you do not

follow these actions, the device will time out

and you will have to repeat the procedure.

Follow these steps to program up to three

channels:

1. Make sure that your key is in the

ACCESSORY position and the engine is off

while programming the transmitter.

2. Press the two outside buttons at the same

time for one to two seconds, and immediately

release them.

178

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 621 622

Commentaires sur ces manuels

Pas de commentaire