Chevrolet LUMINA 1999 Manuel du propriétaire télécharger pdf (Page 99)

2-32

Setting Cruise Control

CAUTION:

If you leave your cruise control switch on when

you’re not using cruise, you might hit a button

and go into cruise when you don’t want to. You

could be startled and even lose control. Keep the

cruise control switch off until you want to use

cruise control.

1. Move the cruise control switch to ON.

2. Get up to the speed you want.

3. Push in the SET button at the end of the lever and

release it.

4. Take your foot off the accelerator pedal.

Resuming a Set Speed

Suppose you set your cruise control at a desired speed

and then you apply the brake. This shuts off the cruise

control, but you don’t need to reset it when you want to

resume your previous speed.

Once you’re going about 25 mph (40 km/h) or more,

you can move the cruise control switch from ON to

R/A (Resume/Accelerate) briefly. You’ll go right back

up to your chosen speed and stay there.

Increasing Speed While Using Cruise Control

There are two ways to go to a higher speed:

Use the accelerator pedal to get to the higher speed.

Push the SET button at the end of the lever, then

release the button and the accelerator pedal. You’ll

now cruise at the higher speed.

Move the cruise switch from ON to R/A. Hold it

there until you get up to the speed you want, then

release the switch. (To increase your speed in very

small amounts, move the switch to R/A. Each time

you do this, your vehicle will go about 1 mph

(1.6 km/h) faster.)

The accelerate feature will only work after you set the

cruise control speed by pushing the SET button.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 321 322

Pas de commentaire

Chevrolet LUMINA 1999 Manuel du propriétaire Page 99