Chevrolet 2008 Uplander Spécifications télécharger pdf (Page 360)

100

101

7. Do not let the other end touch metal. Connect it to

the positive (+) terminal of the good battery. Use a

remote positive (+) terminal if the vehicle has one.

8. Now connect the black negative (−) cable to the

negative (−) terminal of the good battery. Use a

remote negative (−) terminal if the vehicle has one.

Do not let the other end touch anything until the

next step. The other end of the negative (−) cable

does not go to the dead battery. It goes to a

heavy, unpainted metal engine part, or to a remote

negative (−) terminal on the vehicle with the

dead battery.

9. Connect the other end of the negative (−) cable at

least 18 inches (45 cm) away from the dead battery,

but not near engine parts that move. The electrical

connection is just as good there, and the chance

of sparks getting back to the battery is much less.

10. Now start the vehicle with the good battery and run

the engine for a while.

11. Try to start the vehicle that had the dead battery.

If it will not start after a few tries, it probably needs

service.

Notice: If the jumper cables are connected or

removed in the wrong order, electrical shorting may

occur and damage the vehicle. The repairs would

not be covered by your warranty. Always connect

and remove the jumper cables in the correct

order, making sure that the cables do not touch

each other or other metal.

A. Heavy, Unpainted Metal Engine Part or Remote

Negative (−) Terminal

B. Good Battery or Remote Positive (+) Terminal and

Remote Negative (−) Terminals

C. Dead Battery or Remote Positive (+) Terminal

Jumper Cable Removal

5-40

1 2 ... 355 356 357 358 359 360 361 362 363 364 365 ... 475 476

Commentaires sur ces manuels

Pas de commentaire

Chevrolet 2008 Uplander Spécifications Page 360

Commentaires sur ces manuels

Produits connexes et manuels pour Siège de voiture Chevrolet 2008 Uplander